Here is the content list:

l The release of Deep cycle AGM battery

l Installation of Deep cycle AGM battery

l Features of our Deep cycle AGM battery

The release of Deep cycle AGM battery

1. The continuous discharge current cannot be greater than 3CA, and the maximum discharge current (5s) should be less than 6CA.

2. Charge the Deep cycle AGM battery immediately after discharge. Do not store batteries until fully charged. If the Deep cycle AGM battery is discharged without charging for a long time, it cannot be restored to full capacity.

Installation of Deep cycle AGM battery

1. Before installation, please confirm that the appearance of the Deep cycle AGM battery is normal. The battery should be installed firmly and safely to avoid impact or deformation.

2. When the battery is installed on the device, please keep it away from the heater (transformer, etc.). Install as vertically as possible and ensure good ventilation.

3. The battery may release harmful gas. Do not install it in a closed place and keep away from flammable materials (switches, fuses).

4. Do not cover or pack the battery with vinyl chloride, otherwise, it may cause damage to the battery.

5. Do not twist the battery terminals or solder directly.

6. Avoid exposure to sunlight. Avoid exposure to high-intensity infrared or ultraviolet light. Avoid contact with organic solvents, mist, dust, and corrosive gases. Avoid undue vibration.

7. When the battery is connected to the charger or load device, please make sure the switch is off. The positive pole of the battery is connected to the positive pole of the charger or device, and the negative pole is connected to the negative pole.

8. Do not mix batteries of different capacities or types. Also do not use new and old batteries at the same time.

9. If the Deep cycle AGM batteries need to be connected in parallel, please contact us.

Features of our Deep cycle AGM battery

1. Deep cycle design, 4BS leading the previous technology: long service life.

2. Unique corrosion-resistant grid alloy with, a special lead wire design, the Deep cycle AGM battery has good deep discharge ability and recovery ability after deep discharge.

3. Radial plate design, tight assembly technology: high-efficiency discharge performance.

4. High-quality gas-phase silica gel electrolyte: no flow, no leakage, and each part of the plate react evenly.

5. High purity of raw materials: low self-discharge rate.

6. Oxygen composite technology: safe and environmentally friendly.